Descrizione
Four-piece Magigoo solution for professional print bed adhesion. Contains adhesive for polyamide, polycarbonate, polypropylene, and ABS filaments.
The PRO Kit was developed for professional use in combination with technical materials.
These adhesives ensure that prints adhere well while the plate is hot and are easy to remove once the plate has cooled. Additionally, adhesive residue is easy to clean.
Content:
Magigoo PA was developed for professional use exclusively with polyamide filaments. It is designed and tested for a wide range of PA (nylon) brands and fiber-reinforced filaments.
Magigoo PC was developed for use exclusively with polycarbonate filaments and fiber-reinforced variants.
Magigoo PP was developed for use exclusively with polypropylene filaments.
Magigoo ABS was developed for general use with a wide range of popular filaments. It is particularly suitable for ABS, PLA, HIPS, PETG, TPU, and similar filament types.
Advice:
Shake well before use.
Apply the Magigoo by pressing the bottle's nozzle onto the print bed. This opens the cap inside and the material can be applied.
Print according to the filament manufacturer's recommendations.
For larger prints we recommend a 20mm "Brim", or frame.
Wait until the print is finished and the print bed has cooled. The print should separate slightly from the plate.
If you have difficulty removing it, you can, if possible, put some water on the print bed and then wash the print.
Clean the printing plate with a cloth moistened with water.
Safety instructions:
These products are designed for professional use. Please read the instructions carefully before use.
Using the wrong type of filament with the wrong Magigoo adhesive can cause over-adhesion and damage your print bed.
Some adhesives may contain substances that cause corrosion and eye irritation. Wash your hands after use. Ideally, we recommend nitrite gloves when handling adhesives.
If you have any further questions, please do not hesitate to contact us or the manufacturer directly.
Magigoo bottles have a spring-loaded cap. To open the bottle, you need to press the cap onto the print bed.
If you squeeze the sides of the bottle, the front cap may pop off. Please never squeeze the sides of the bottle!
